Radiator Flush (Need Help)

B

BatGirl

New Member
Hey all,

I'm getting ready to flush the radiator in my 92 ranger 4cyl, where is the drain plug?

I'm no stranger to the underbelly of a car, but I've never worked on this truck before, so I don't know what I'm looking for and don't want to screw it up. Any help would be greatly appreciated.



I'm new to this forum so I'll make this my introduction as well.

My name is Rachel, I drive a truck and ride a motorcycle. Short and sweet.
 
Passenger side lower corner. But its a lot easier just to remove the lower rad. hose for the drain and remove the upper rad. hose to put the water through. When the truck gets that old, you can bust the plastic wing nut off in the radiator. PITA to remove it.
 
i know on my truck brad the drain is on the drivers side.... and taking the lower radiator hose off the radiator is alot easier and cheaper if you have to replace the hose.....
 
Found it. Driver's side, lower rear corner of the radiator. Looks like the previous owner snapped off one of the wings, but it was no problem to loosen. Just ran the flush/water solution through and waiting for the truck to cool down. I'll probably replace the hoses and clamps next time I flush it out. Thanks for the advice everyone :)
 
You must log in or register to reply here.
Back
Top