tie down mounts

  • Thread starter Thread starter Diabolical Ranger
  • Start date Start date
D

Diabolical Ranger

Guest
do they still make this kind of mount tie down, only with a square rubber block that fits a ranger bed, or does the ranger not have the square holes in the bedrail, I have a plastic cover over mine and never seen whats under it
 
Last edited by a moderator:
Thanks Pete, I am always a day late and a dollar short lol

how many square holes does the ranger stepside box have?
 
I guess I was wanting to hear 6 like the longbeds have

I need one in the middle on each side but maybe the ones at the rear will do, if they are at the rear hahaha
 
Actually craig I don't think yours will have the holes in top of the bed rail mine doesn't mine has the cleat type inside the bed. Under the bedrails is the bolts that bolt the bedside onto the inner bed frame.
 
Far as I know, the stepsides have NO tiedown points on top of the bed. Only bolted to the side.

images
 
thanks guys, I need to mod a couple on there just to put a cable lock through it and the bike when in there.
 
That's nothing a 1/2" drill bit won't fix :thumbsup:

I got some of the rectangular tie down's at wally world a while back, but I think I saw them on harbor freight too.

They have the rectangular plate & rubber block with a toggle bolt kinda deal on the bottom.
With my front hooks I drilled through my bed rails & didn't use the rubber blocks, just the toggle bolt holding under the bed rails.

Here's the HF ones LINKY
 
just picked up a couple of these bad boys, not bad for 8 bucks for 2
 
Last edited by a moderator:
Craig, our beds do not have the holes, you wont be able to put them in either. the plastic caps cover where the fiberglass attaches to the steel bed box, it is not flat under those caps so there isnt a way to even mount them up
 
so what is under that plastic cover just an opening? I can drill a hole maybe take that cover off and weld a piece of flat stock just to dill a hole and mount on top of the plastic cover, not goint to be used for anchor purpose but basically theft deterent of bike running a cable lock through the eye opening of the mount where they just cant lift out very easily., mayber I can mount it on the side wall or even through the floor of the bed .

got any pics of what is under that plastic cover???
 
or just drill through the plastic cover and mount maybe no one would know it's not very secure but it would make noise if they just try to rip it out of the plastic any thoughts?
 
Under the opening is the fiberglass "cap" which mounts the upper part of the flareside to the steel bed box. I dont have pics of what it looks like but when that cap comes off it looks like crap. The anchors for flareside beds mount on the inside, front and rear of the wheel wells. they are similar to these
2954f693.jpg


You can drill a hole in the sides and then mount them in with self tapping screws/bolts
 
yeah, I have those but can not put a cable through them.
time to get the sawzall and welder and BFH out (big fkng hammer ) or just drill a hole in floor or side lol
thanks Clinton for the good news lol
 
Yeah those are the original ones. you can drill them out and replace them with ones like I have. I have 2 sets, 1 set is spoken for but I can send you the others so you dont chop holes in the floor!
 
You must log in or register to reply here.
Back
Top