NEED some tech help on t-case motor

S

samuelghoggatt

New Member
My Mechanic is telling me that I need to replace my t-case shift motor. It seems simple to pull it off and put a new one on. He said something about testing and calibrating with an electrical tool or some sort. I was wondering if anyone could tell me if replacing the t-case motor is "simply pulling the old one off and putting the new one on" or if there is more to it than that. thanks guys
 
What makes you think your shift motor is bad? Can you hear the "clunk" when it shifts? Do your front axles not engage? Are your locking hubs OK?

A few yrs ago, my shifter wasn't working (no 4x4). Was it seized from lack of use? Bad electrical connections? I no longer recall why. I knew nothing about my 4x4 back then, incl. that it had a shift motor.

I unbolted mine, took it apart, cleaned it up, then reinstalled it again. Presto! It worked great, ever since. So I didn't need any "calibration". Nor a new one. See http://www.therangerstation.com/tech_library/TCaseshiftmotor.htm

I read that it needs to be operated about every month, for internal lubrication, so I just switch into 4x4 mode to exercise it whenever it rains.
 
Last edited:
I recently had my hubs, bearings, and four wheel drive redone and serviced. The reason I agree with my mechanic on the shift motor being bad is because i have 4 wheel drive high, but it wont engage into four wheel low. AKA, the t-case wont shift over into low gearing. The four wheel drive works and hubs engage.
 
You must log in or register to reply here.
Back
Top