fog lights can i do this?

Captured Time

Captured Time

watch this and hold on
ok i am having problems with my fog lights butning out fast ( think its in the conector ) any way i am looking into some new fogs and want to know it i can hard wire the new ones into my stock wire's so i can use my fog light switch?
 
You may be able to, you should pm Buggman, he is the guru with that stuff. It all depends on matching the proper wiring and identifying stock wiring and aftermarket.
 
if i am not mistaken clinton buggman made a pigtail that would allow you to hook up aftermarket fogs to the oe switch.....
 
If you suspect it's the connector that's causing your fog lights to burn out, then wouldn't that connector also cause your New fog lights to burn out, if they are attached?
 
machine said:
If you suspect it's the connector that's causing your fog lights to burn out, then wouldn't that connector also cause your New fog lights to burn out, if they are attached?
Click to expand...

BisketFx4 said:
X2 I was thinking the same thing
Click to expand...


is what i want to do is tap int to the power and switch wires and the ground before the wires get to the connector. i had kinda the prob on my 98 but it was blowing out my head lights and ford put in new connectors

when i get to my truck i will podt a pic of what im talking bout
 
just keep the wire on the new lights same size as the oem wire size you should be fine
 
Diabolical Ranger said:
just keep the wire on the new lights same size as the oem wire size you should be fine
Click to expand...

The wiring on the Ranger is setup for 35watt/ea lighting so if your new lights are 55w/ea then although it will work by just connecting the new to the old, after a while the wiring will cause a problem, may even burn out a relay or just char it enough to work some of the time, PITA.

Best bet , there are two.

1) If you want to keep the OEM Switch - get the Buggman Harness and mate the Light Harness to it. This method allows you to keep the existing OEM switch and allows the lights to run off of the new harness to get full current.

2) If you want to use just the new harness that comes with the lighting by itself. This eliminates the Buggman Harness and allows you to run any switch you want and will allow full current to reach the lights.

Both end results are what you want full reliable current reaching the light WITHOUT A PROBLEM.
 
Last edited:
You must log in or register to reply here.
Back
Top