Drivetrain reinstallation stuck

Discussion in 'Drivetrain Tech' started by NickR, Apr 14, 2019.

  1. NickR

    NickR New Member

    1999 Ranger 2.5L MT 5speed

    I replaced,the clutch. Everything was going well until I tried to reinstall the drivetrain.
    The spline lines up and goes in, but not far enough to bolt the rear end universal.
    Any ideas? I just figured it would slide right in, but no. I am about a half inch to long in the rear.

    The splines all look clean what am I doing wrong?


Share This Page