Discuss: Video How To: OHC Install

Discussion in 'How-To Submissions' started by pooleo, Apr 2, 2012.

Page 2 of 2
  1. El Camino Man

    El Camino Man Thank The Lord For BBFs!

    Well guys, heres where Im at:

    [​IMG]

    Its in! The damn things in! I just went ahead and did the power wire and nothing else. I WILL NOT remove my headliner again unless something is completely fudged up! Im awaiting a temp sensor from Pete then it oughta read something other than OC lol. I am SOO happy its basically over with! Thanks guys!
     
    El Camino Man, Apr 6, 2012
    #21

  2. Ranger Forum Sign Up!

    Join RangerForum.com Today - It's Totally Free!

    Are you a Ford Ranger fan? If so we invite you to join our community and see what it has to offer. Our site is specifically designed for you and it's a great place for Ford Ranger Fans to meet online.
    Once you join you'll be able to post messages, upload pictures of your Ford, and have a great time with other Ranger fans. Whether your an old timer or just bought your Ford you'll find that Ranger Forum is a great community to join. Best of all it's totally free!

    Join RnagerForum.com Today! JOIN FOR FREE

  3. mcdonald58

    mcdonald58 New Member

    ill use this when/if i install mine. i just have get over cutting the headliner and completely figure out the wiring. you dont have to cut any of your factory wiring right?
     
    mcdonald58, Apr 11, 2012
    #22
  4. El Camino Man

    El Camino Man Thank The Lord For BBFs!

    Just tap it. I learned that the hard way lol
     
    El Camino Man, Apr 12, 2012
    #23
  5. OP
    pooleo

    pooleo New Member


    Wiring is real easy. And for the headliner cut, just start small. You can actually keep the cut about an inch narrower than the bracket and be ok. Just use the bracket for the width measurement.

    Follow the video and line up that tab with the roof.

    You can do it! :thumbup:
     
    pooleo, Apr 12, 2012
    #24
  6. mcdonald58

    mcdonald58 New Member

    how do you guys recommend making the slots in the roof where the bracket snaps into
     
    mcdonald58, Apr 12, 2012
    #25
  7. OP
    pooleo

    pooleo New Member

    Well, once you bolt the bracket in a drill and good bit work great. Thats in the video also. I used a 1/4" cobalt bit.

    My first one I installed I used a dremel, that was bad because of the sparks, it burned up the headliner
     
    pooleo, Apr 12, 2012
    #26
Page 2 of 2

Share This Page