currently working on a new mod....

[klinger86]

Well guys version 1 failed miserably. Back to the drawing board and to start work on version 1.1.

 

[00redranger]

How'd it fail?

 

[klinger86]

with the parking lights on the turns on the front wouldnt work.... so i have to figure out how to isolate the two wires so it can come on with the parking lights and still flash with the turn signals....

 

[Diabolical Ranger]

relay

 

[klinger86]

dont know if a relay would work with this.... hmmmmm now that you mention it it may work.... but have to find a relay schematic and figure out how to wire it up....

 

[buggman]

That diagram doesn't show pin 87a in the center, but 87 & 87a will have the opposite output.
If 87 has 12v out 87a will have 0v & if 87a has 12v out 87 will have 0v out.

 

[klinger86]

That diagram doesn't show pin 87a in the center, but 87 & 87a will have the opposite output.
If 87 has 12v out 87a will have 0v & if 87a has 12v out 87 will have 0v out.

so basically 86 will be the flasher 85 will be the ground 30 will be the constant and 87 will go to the corner.... correct?

 

[buggman]

I think so. lol
Either 87 or 87a to the new bulb.

 

[klinger86]

here's a better diagram....

now just to play around with it and see if i can get it to work.....

 

[klinger86]

ok here is another schematic it is for converting a 3 bulb tail to a 2 bulb steup it should work for what i am doing.... the only thing that sucks is it will end up using 4 relays.... and some diodes....