Please feel free to move this to a more appropriate thread if this is not the correct section. Hello, Replacing brakes is not overly difficult, in my experience. However it is always the mundane details that whip my tail and make an hour job an entire afternoon. When I recently replaced the front brake pads on my 04 ranger 2wd, I did not pay attention to the mundane detail that the caliper slide bolts are made differently, although threaded alike. One goes in the top and the other in the bottom. If the answer is on Y**Tub*, I havent been able to find it. Is there a rule of thumb as to which bolt goes where? Appreciate the help ahead of time.