Stall problem

Discussion in 'General Discussion' started by Bob Ludwig, Jan 30, 2022.

  1. Bob Ludwig

    Bob Ludwig New Member

    I have a 1996 Ranger with 4.0 and 5 speed. Recently while driving away from a stop sign it just stalled and fell on it's face, I let up on the throttle and then pushed it down again and it took off but then stalled again. It acts like the ignition turns off then back on. I jacked it up and put it on stands with the rear wheels off the ground. It runs like a charm and I'm unable to replicate the problem. Off the stands and begin to drive and it stalls again. I've replaced the fuel pump relay and idle control sensor. I'm at wits end !!!
    Anyone else ever have this problem or any suggestions ??
     
  2. Ranger Forum Sign Up!

    Join RangerForum.com Today - It's Totally Free!

    Are you a Ford Ranger fan? If so we invite you to join our community and see what it has to offer. Our site is specifically designed for you and it's a great place for Ford Ranger Fans to meet online.
    Once you join you'll be able to post messages, upload pictures of your Ford, and have a great time with other Ranger fans. Whether your an old timer or just bought your Ford you'll find that Ranger Forum is a great community to join. Best of all it's totally free!

    Join RnagerForum.com Today! JOIN FOR FREE

  3. RangerAl

    RangerAl Member

    Basic tune up.. plugs (motorcraft), wires, fuel filter, air filter, clean MAF sensor, check for crank sensor connector for oil leak, and finally the cam synchronizer sensor (where distributor used to be).
     

Share This Page