I am sure this has been done to death and have seen various posts but just wondering a couple of questions: The truck is a 2009 Supercab, which is an ex electricity board, it's had a fair few extras fitted all round. It has twin batteries and now a fairly hefty winch fitted. I have removed the ladder rack. Everything else is standard The mounts are fabricated by myself in a proper agricultural fashion but do the job! Since fitting it, the whole front end feels a bit different and there is not much gap to the bump stops, would adjusting the torsion bars a bit help improve this as there is quite a lot of weight at the front end now? Doesn't seem to sit any lower but forgot to take measurements!! Thanks for any advice.