Search results

Hello All, Been a while since I have posted. I have managed to get a lot more done to my 96 5.0 swap. I am still having difficulties with keeping it cool. I have used the 96 Ranger heavy duty radiator (4 core), a 180 deg thermostat and still it will run hot at a drive through. I have a new...

Has anyone seen or heard anything about putting a 5.4 F150 lightning powertrain into a ranger? I may have that opportunity and i am looking for info.

I think I found the answer, did a search for the part number. Found a post on the ford truck forum, turns out it is the resistor for the DRL. Back to the salvage yard... anyone have a photo and location of the sensor I need? Thanks, elkfever New User Garage is empty, add now Join Date: Aug...

There are seven wires going to the connector. The part only uses four of them, GRY/WHT, LT GRN/RED, LT GRN/BLK, PPL/WHT. I tired looking up the part number at fordparts.com but could not find it.

I have posted some updated photos in my garage of some recent changes.

Hello all, I need some help. I am trying to install the OHC in my ranger from an Explorer. I was at the salvage yard the other day looking for the outside air temp sensor. The part number on the what I found is F0EB- 14A624-A. Let me know if I found the right part. It was mounted on the...

Made a few upgrades inside and out... check out the garage now. Dean

I agree about the pump. The bed is fairly easy to remove. Disconnect taillight wiring (under the bed at drivers side rear), remove six bolts holding the bed on, and remove the fuel cap and three screws attaching filler neck to the bed. Be prepared to change the fuel filler pipe at the same...

Added new photo today in my garage.

That is some really good work!

I really do like the seats. I have found on one of the forums that there is a list of seats that you can transplant into your ranger. Ford Escort seats are pretty popular for having the halo headrest. The ones I used bolted right in, I did not have to change the seat tracks.

Just added new pics in my garage. I like my new wheels!

Added new pics!

Try again...

Let's see if I have gotten the signature right...

I think I am going to go with the hubcentric adapters, I will use the steel lockwashers. I found the wheels I want to use. 2001 Lincoln LS factory polished aluminum. They look really good, 16".

Does anyone have a step by step procedure to put a bronco II fuel tank into a 96 Ranger. I have lots of questions. Wiring is a no brainer, buy more wire and solder both ends, keep the right colors. Where do I relocate the fuel filler to? What can I use to lengthen the fuel lines, or do I...

Thanks for the compliments. Give me time and will get a lot better.... Looking at the pics I have seen of your trucks, you guys have done a lot of excellent work!

I had to use the yoke from the T-Bird and a conversion U-Joint. That will do for now. When I upgrade to the 5.0 I will use the shaft from the donor vehicle and have it cut down or lengthened to meet the diff. There are halfshafts that go in, I was pulling the rear diff to have it rebuilt when...

Wheel pattern I will research out the best solution for me. Thanks for your help. I will keep this updated as I go.